Uses

Urethane & varnish removal.
Lead-based, latex & enamel paint removal.
Two part epoxies (solid count < 40%).
Strip wood floors without the odor and dust.

Coverage

Horizontal - 200 sq.ft. per gallon.
Vertical - 130 sq.ft. per gallon.

Description

Super-Stripper™ is an industrial strength and consumer friendly paint, varnish, and urethane remover made from 100% American grown soybeans. The low evaporation rate of Super-Stripper™ and its gel formulation make it possible to remove several layers of paint in one application.

During the removal of lead based paint, lead becomes encapsulated in the gel, preventing air born lead particles, allowing for safe and easy disposal. Super-Stripper™ contains no methylene chloride, is not an alkaline based stripper and cleans up easily with water.

Unlike more traditional paint strippers Super-Stripper™ lets you work without the odor. Indoors or outdoors, you can be guaranteed a safe restoration process with Super-Stripper™.

Application

Super-Stripper™ is safe to use on wood, brick stone, concrete, metal, plaster, and many other surfaces. Do not use on plastic, PVC, rubber or dry wall. Super-Stripper™ may be used indoors or outdoors. If used outdoors, tenting with a thin mil, plastic drop cloth will prevent the wind from prematurely drying the area. Super-Stripper™ may be used on vertical as well as horizontal projects.

Use a brush or airless sprayer to apply a uniform coating of Super-Stripper™ 1/8" inch thick. If using a brush, do not apply as in painting by over brushing previous strokes. Use the brush to lay the Super-Stripper™ on the surface. The number of layers and types of coatings will determine the amount of time needed for Super-Stripper™ to work.

Check the progress of the stripping action by using a scraper to see if the coating has been lifted from the surface. If not, wait longer and recheck. As long as Super-Stripper™ is wet, it is working. Let the stripper do the work.

Once the coating is lifted from the surface, remove it with a scraper or other stripping tool. Clean the remaining thin residue with water and a fibrous scrub pad.

Precautions

If used on fiber glass surface and dulling occurs, restore luster by using rubbing compound. For prolonged periods, 18 hours or more, damage could occur. For veneer finishes, exposure should be in short intervals, 5-10 minutes. Longer exposure times could result in damage. Not for use on PVC.